This website uses cookies primarily for visitor analytics. Certain pages will ask you to fill in contact details to receive additional information. On these pages you have the option of having the site log your details for future visits. Indicating you want the site to remember your details will place a cookie on your device. To view our full cookie policy, please click here. You can also view it at any time by going to our Contact Us page.

Miniaturised fuel cell makes drones fly more than one hour

11 March 2016

A fuel cell developed by Prof. Gyeong Man Choi and his research team is designed to replace lithium-ion batteries in smartphones, laptops and drones.

Shutterstock image

Drones are used for various applications such as aero picturing, disaster recovery, and delivering. Despite attracting attention as a new growth area, the biggest problem of drones is its small battery capacity and limited flight time of less than an hour. 

Prof. Choi and his Ph.D. student Kun Joong Kim have developed a miniaturised solid oxide fuel cell (SOFC) to replace lithium-ion batteries in smartphones, laptops, drones, and other small electronic devices. 

Their research can be utilised, not only for a small fuel cell, but also for a large-capacity fuel cell that can be used for a vehicle.

The SOFC, referred to as a third-generation fuel cell, has been intensively studied since it has a simple structure and no problems with corrosion or loss of the electrolyte. This fuel cell converts hydrogen into electricity by oxygen-ion migration to fuel electrode through an oxide electrolyte. Typically, silicon has been used after lithography and etching as a supporting component of small oxide fuel cells. This design, however, has shown rapid degradation and poor durability due to thermal-expansion mismatch with the electrolyte, and thus, it cannot be used in actual devices that require fast on/off.

The research team developed a new technology that combines porous stainless steel, which is thermally and mechanically strong and highly stable to oxidation/reduction reactions, with thin-film electrolyte and electrodes of minimal heat capacity. Performance and durability were increased simultaneously. In addition, the fuel cells are made by a combination of tape casting-lamination-cofiring (TLC) techniques that are commercially viable for large scale SOFC.

The fuel cells exhibited a high power density of approximately 560mW per square centimetre at 550°C. The research team expects this fuel cell may be suitable for portable electronic devices such as smartphones, laptops, and drones that require high power-density and quick on/off. They also expect to develop large and inexpensive fuel cells for a power source of next-generation automotive. 

With this fuel cell, drones can fly more than one hour, and the team expects to have smartphones that charge only once a week.

This research was supported by the Basic Science Research Program through the National Research Foundation of Korea (NRF) funded by the Ministry of Education, Science and Technology.

Their results were published in the March edition of Scientific Reports, the sister journal of Nature.

More information can be found on the Postech University website


Print this page | E-mail this page