This website uses cookies primarily for visitor analytics. Certain pages will ask you to fill in contact details to receive additional information. On these pages you have the option of having the site log your details for future visits. Indicating you want the site to remember your details will place a cookie on your device. To view our full cookie policy, please click here. You can also view it at any time by going to our Contact Us page.

Fully integrated proximity probe

24 August 2016

Sensonics introduced a new range of proximity sensors with an integrated driver suitable for measuring shaft vibration, position and speed on rotating plant.

Building on the Senturion proximity probe range, the new PRI Series offers a single probe assembly solution with direct processed outputs.

The PRI series provides complete functionality in a single probe assembly mounted on the machine, offering either a M12 connector interface for the 5mm range probe or an integral cable for the 2mm range option.

A typical application that the PRI range probe is ideally suited to is the monitoring of large marine diesel engines where the use of separate drivers is not a preferred solution due to the high channel count and associated expense. Monitoring of piston BDC (bottom dead centre) position during engine operational hours is a critical measurement to determine wear in crank bearings and permits the owner to plan maintenance intervals well in advance, essential for marine operations. The probe temperature range is limited to 80°C due to the integrated electronics and is also suitable for most pumps, fans and hydroelectric generator vibration monitoring applications. Removing the need for the separate driver and associated housing provides a significant cost saving with no compromises in measurement accuracy.

The PRI series offers processed outputs of shaft vibration and position through a 4 - 20 mA current loop and is ideal for OEM applications, connecting directly to the local machine PLC or a plant wide DCS. Customised outputs are also available on request for specific applications.

The probe also provides a raw buffered output of the measured signal that can be utilised through portable analysis equipment for a more detailed picture of the dynamic performance of the machine.  


Contact Details and Archive...

Print this page | E-mail this page