This website uses cookies primarily for visitor analytics. Certain pages will ask you to fill in contact details to receive additional information. On these pages you have the option of having the site log your details for future visits. Indicating you want the site to remember your details will place a cookie on your device. To view our full cookie policy, please click here. You can also view it at any time by going to our Contact Us page.

DELO introduces a new adhesive for power semiconductors

02 June 2020

DELO has developed a new electronic adhesive that is both thermally conductive and electrically insulating and shows good strength even after standardised humidity tests with subsequent reflow cycles.

DELO MONOPOX TC2270 ensures fast heat transfer and long-term reliable operation of semiconductors in power electronics.
 
A common reason for the failure of power semiconductors is the heat development in the often very small components, as there is usually no efficient heat dissipation. Adhesives not only ensure a permanent bond, but also dissipate heat and provide electrical insulation.
 
The new electronic adhesive from DELO is a one-component, heat-curing epoxy resin. Due to its ceramic filler aluminium nitride it provides very high thermal conductivity of 1.7 W/(m·K) (measured by the criteria of ASTM D5470). This is comparable with silver-filled isotropic conductive adhesives (ICA), which have a thermal conductivity of ~1.5-2.0 W/(m·K).
 
One advantage of DELO MONOPOX TC2270 over ICA is that it also provides electrical insulation. The adhesive thus ensures both reliable heat dissipation and electrical insulation of assemblies. Using the new electronic adhesive additionally allows proportionate component costs to be reduced.
 
In cured condition, DELO MONOPOX TC2270 has a compression shear strength of 34 MPa on the FR4 composite material and of 11 MPa on high-performance LCP plastics. When bonding microchips, the electronic adhesive reaches values of 60 N in the die shear test (1x1 mm² silicon dies on gold surface). Even after standardised humidity tests, DELO MONOPOX TC2270 shows good strength. To determine the moisture sensitivity level (MSL 1), silicon dies were bonded to different PCB materials, stored for one week at 85 °C and 85% air humidity, and then subjected to three consecutive reflow cycles. Even with these loads, the adhesive retained its high strength level.
 
To enable the bonding of temperature-sensitive assemblies and prevent them from damage caused by excessive curing temperatures, the adhesive has been designed with a chemical system, ensuring that final strength is reached after 90 minutes at a curing temperature of 60°C. With a temperature of 80°C, the curing process can be reduced to 15 minutes. In this way, production processes can be individually adapted to the component types and quantities to be manufactured. The adhesive's service temperature range is between -40 and +150°C.


Contact Details and Archive...

Print this page | E-mail this page

Igus - Tech Up, Costs Down