Die-Cast IP 66 enclosures with in-built EMC shielding
31 October 2008
The new 'conFORM' enclosures from Rolec are specially designed to protect highly sensitive electronic components against radio frequency interference. They have been successfully EMC performance tested by Hanover University in Germany.
The enclosures are manufactured from die-cast aluminium GD AL Si 12, and feature small ribs on the inside of the base section which are compressed by the lid to form a high performance EMC contact between the two parts. As a result, the ‘conFORM’ range is very competitively priced as expensive and delicate EMC gaskets, or contact fingers, are not required.
The ‘conFORM’ range is available in 14 standard sizes with external dimensions from 79 x 84 x 44mm to 266 x 166 x 100mm. All models are sealed to IP 66, or on request, to IP 67 with a special gasket. The enclosures are powder painted silky grey, RAL 7032 as standard, or silver grey, RAL 7001 at no extra cost.
All mounting dimensions conform to industry standard sizes. Accessories include internal mounting plates, external mounting brackets, internal and external hinges, panel mounting kits and terminal mounting DIN-Rails.
Contact Details and Archive...