This website uses cookies primarily for visitor analytics. Certain pages will ask you to fill in contact details to receive additional information. On these pages you have the option of having the site log your details for future visits. Indicating you want the site to remember your details will place a cookie on your device. To view our full cookie policy, please click here. You can also view it at any time by going to our Contact Us page.

Cable entry system meets IP69K protection rating

04 June 2015

The new KDL/H 24 cable entry system from Murrplastik meets protection rating IP69K for high-pressure water cleaning at high temperatures.

The KDL/H 24 cable entry system is produced as a powder-coated zinc die casting and is suitable for feed-through of preconfigured cables in rugged outdoor environments, as well as environments where it might be exposed to high mechanical stresses, moisture, acids, alkalis, alcohols, mineral oils, cleaning agents, grease, and dust.

The feed-through is resistant to high pressure steam jet cleaners; it is fully UV and ozone resistant and can be deployed over a temperature range of -40°C to +100°C. The KDL/H 24 and accessories also offer a flammability rating of UL94–V0.

KDL/H 24 is equipped with a grommet block made from TPE, which fixes the sleeves behind the metal frame and locks each feed-in cable tightly with built-in strain relief. It is virtually impossible for the grommets to be torn out, even under extremely high mechanical stresses.

Instead of locking the cable plus a sleeve from the top into the cable entry system, as is usually the case, cable feeds are placed into the grommet block; the grommet block is then pressed into the cut-out, the cables are placed in the appropriate grommets and finally, each individual grommet is pressed into the grommet block.

The frame itself is mounted on the grommet block and screw fastened with 4x M5 bolts. Assembly is achieved from the front.

The capacity of KDL/H 24 is 48 cables. Ten different sleeve variations with clamping ranges of between 2 to 12mm are available. KDL/H 24 installation dimensions are suitable for the heavy-duty 24-pin Harting and Wieland connector standard cut-outs.

For more information, click here.

Contact Details and Archive...

Print this page | E-mail this page

Coda Systems