Bonelike 3D silicon has potential for use with medical devices
09 July 2015
Seeking better ways to integrate medical devices with biological systems, researchers have used a chemical process to produce silicon spicules.
Researchers, led by Bozhi Tian, assistant professor in chemistry at the University of Chicago (UChicago), have developed a new approach for better integrating medical devices with biological systems, producing the first skeleton-like silicon spicules ever prepared via chemical processes.
"Using bone formation as a guide, the Tian group has developed a synthetic material from silicon that shows potential for improving interaction between soft tissue and hard materials," says Joe Akkara, a programme director in the US National Science Foundation materials research division, which funds this research. "This is the power of basic scientific research. The Tian group has created a material that preliminarily seems to enhance soft tissue function."
In an article published in the journal, Science, Tian and his co-authors from UChicago and Northwestern University describe their new method for the syntheses and fabrication of mesocopic three-dimensional semiconductors (the mesoscale is intermediate between the nanometre and macroscopic scales).
"This opens up a new opportunity for building electronics for enhanced sensing and stimulation at bio-interfaces," says lead author Zhiqiang Luo, a postdoctoral scholar in Tian's laboratory.
The team achieved three advances in the development of semiconductor and biological materials. One advance was the demonstration, by strictly chemical means, of three-dimensional lithography. Existing lithographic techniques create features over flat surfaces. The laboratory system mimics the natural reaction-diffusion process that leads to symmetry-breaking forms in nature: the grooved and notched form of a bee stinger, for example.
Tian's team developed a pressure modulation synthesis, to promote the growth of silicon nanowires and to induce gold-based patterns in the silicon. Gold acts as silicon's growth catalyst. By repeatedly increasing and decreasing the pressure on their samples, the researchers were able to control the gold's precipitation and diffusion along the silicon's faceted surfaces.
"The idea of utilising deposition-diffusion cycles can be applied to synthesizing more complex 3D semiconductors," says co-lead author, UChicago's Yuanwen Jiang.
3D silicon etching
The semiconductor industry uses wet chemical etching with an etch-resist to create planar patterns on silicon wafers. Portions of the wafer masked with thin film physically block the etching from being carried out except on the open surface areas.
In another advance, Tian and his associates developed a novel chemical method that instead depends upon the uncanny ability of gold atoms to trap silicon-carrying electrons to selectively prevent the etching.
Much to their surprise, the researchers found that even a sparse cover of gold atoms over the silicon matrix would prevent etching from occurring in their proximity. This method also applies to the 3D lithography of many other semiconductor compounds.
"This is a fundamentally new mechanism for etch mask or etch resist," Tian said. "The entire process is chemical."
Further testing revealed the project's third advance. The testing showed that the synthetic silicon spicules displayed stronger interactions with collagen fibres than did currently available silicon structures. Tian and his associates inserted the synthetic spicules and the other silicon structures into the collagen fibres, then pulled them out. An atomic force microscope measured the force required to accomplish each action.
"One of the major hurdles in the area of bioelectronics or implants is that the interface between the electronic device and the tissue or organ is not robust," says Tian. The spicules show promise for clearing this hurdle. They penetrated easily into the collagen, then became deeply rooted, much like a bee stinger in human skin.